Diameter of 4g52 2L flywheel?

[cheaterparts]

Pretty much what the title says. Does anybody know?

about 10 1/2" with a 110 teeth ring gear about the same size as a vr4 except they run a 106 teeth ring gear
by the way the inside dia of both ring gears are the same so a 106 can be replaced by a 110

[fox]

just borrowing your thread for a moment

Im also looking for a flywheel to fit a 4g52 as the 4g63 flywheel i have is only 5 bolt
would this flywheel be suitable?
its a narrow block 4g63 flywheel,



Im guessing yes since it is 10&1/2 inches in diameter?

[cheaterparts]

just borrowing your thread for a moment

Im also looking for a flywheel to fit a 4g52 as the 4g63 flywheel i have is only 5 bolt
would this flywheel be suitable?
its a narrow block 4g63 flywheel,

the flywheel looks half OK - are you going to run it as a RWD set up
if so there does not look like there is a bore for the spiget bearing it should be about 32 mm( FWD flywheels dont use the spiget bearing )
and count the teeth on the ring gear if it 106 teeth that will need to be changed to 110 teeth - both ring gears have the same ID

hope that is some help

[sig2L]

Hey does any one have a 4g52 ring gear? Can you get them brand new?

[cheaterparts]

Hey does any one have a 4g52 ring gear? Can you get them brand new?

Yes you can still get them new - but my supplier is off atm
I have to get one myself as soon as they are back on deck

[sig2L]

Beauty, do you know what they are worth and any where in Sydney I can get one?

[astronturbo77]

cheater, do you heat the ring gear up with the oxy and tap it off?

[cheaterparts]

cheater, do you heat the ring gear up with the oxy and tap it off?

no heat to remove it - I just tap them off with a drift by working around it bit by bit

heat them up to fit them though

[cheaterparts]

Beauty, do you know what they are worth and any where in Sydney I can get one?

dont know where in sydney but about $ 100 is the going rate