Howdy,
Just wondering if anyone has knowledge of someone who has a lathe, near the Central Coast, that I could use for a day. would only need to be a small hobby lathe for what I require it for. Something about 400mm between centers. Just need to shorten a half shaft axle by 5mm.
cheers,
mick
0438435679
Lathe I could use - Central Coast
- DanTurboLancer
- Posts: 1382
- Joined: Wed Mar 25, 2009 1:19 pm
- Location: Newcastle N.S.W Australia
Re: Lathe I could use - Central Coast
Check out this 'General' section
and look for the tittle
"Who Does Machining and Engineering?"
They are mostly work shops, but if its a 2 minute job someone might be able to help you out.
Hope that helps mate
and look for the tittle
"Who Does Machining and Engineering?"
They are mostly work shops, but if its a 2 minute job someone might be able to help you out.
Hope that helps mate
Re: Lathe I could use - Central Coast
when do you need to do it by?
If you want any sigma-galant.com stickers, then look here for how to get them sigma-galant.com stickers
Re: Lathe I could use - Central Coast
Sooner rather than later. Trying to get her ready for a Wakefield 6hr relay mid next year.
cheers,
mick
cheers,
mick
- DanTurboLancer
- Posts: 1382
- Joined: Wed Mar 25, 2009 1:19 pm
- Location: Newcastle N.S.W Australia
Re: Lathe I could use - Central Coast
mate if you can get it upto Newcastle and leave it with me for a week or so i could do it when i get a chance.
Im mostly out doing site work, but i could do it when i get a chance of an afternoon...
Im mostly out doing site work, but i could do it when i get a chance of an afternoon...
Re: Lathe I could use - Central Coast
Cheers thanks for that. I found someone local so will get it done there. If for whatever reason I get stuck I will send you a pm.
thanks again,
Mick
thanks again,
Mick