Howdy,
Just wondering if anyone has knowledge of someone who has a lathe, near the Central Coast, that I could use for a day. would only need to be a small hobby lathe for what I require it for. Something about 400mm between centers. Just need to shorten a half shaft axle by 5mm.
cheers,
mick
0438435679
Lathe I could use - Central Coast
- DanTurboLancer
- Posts: 1382
- Joined: Wed Mar 25, 2009 1:19 pm
- Location: Newcastle N.S.W Australia
Re: Lathe I could use - Central Coast
Check out this 'General' section
and look for the tittle
"Who Does Machining and Engineering?"
They are mostly work shops, but if its a 2 minute job someone might be able to help you out.
Hope that helps mate![happy :)](./images/smilies/msn_happy.gif)
and look for the tittle
"Who Does Machining and Engineering?"
They are mostly work shops, but if its a 2 minute job someone might be able to help you out.
Hope that helps mate
![happy :)](./images/smilies/msn_happy.gif)
Re: Lathe I could use - Central Coast
when do you need to do it by?
If you want any sigma-galant.com stickers, then look here for how to get them sigma-galant.com stickers
Re: Lathe I could use - Central Coast
Sooner rather than later. Trying to get her ready for a Wakefield 6hr relay mid next year.
cheers,
mick
cheers,
mick
- DanTurboLancer
- Posts: 1382
- Joined: Wed Mar 25, 2009 1:19 pm
- Location: Newcastle N.S.W Australia
Re: Lathe I could use - Central Coast
mate if you can get it upto Newcastle and leave it with me for a week or so i could do it when i get a chance.
Im mostly out doing site work, but i could do it when i get a chance of an afternoon...
Im mostly out doing site work, but i could do it when i get a chance of an afternoon...
Re: Lathe I could use - Central Coast
Cheers thanks for that. I found someone local so will get it done there. If for whatever reason I get stuck I will send you a pm.
thanks again,
Mick
thanks again,
Mick