Hi guys i have a bellhousing to suit an auto behind a narrow block which i was going to use for a t5 manual conversion but it is made of steel and too heavy.
Has anyone come across an alloy one? I dont have a picture of this one but on the trans side the mounting holes are in a nice circular pattern concentric to the input shaft, if that makes sense.
Alloy auto narrow block bellhousings
-
- Posts: 548
- Joined: Wed Sep 21, 2011 1:13 pm
- Location: Sunshine coast ATM
Re: Alloy auto narrow block bellhousings
Not sure for what motor you need but a guy named bill hincher or hinchner or something makes them
All Animals to the Crow: Your not a zoo animal!
Monkey to crow:your just jealous cause noone says "mummy mummy i want to see a crow!"
Monkey to crow:your just jealous cause noone says "mummy mummy i want to see a crow!"
Re: Alloy auto narrow block bellhousings
But if you still want to do you own , I have a alloy bellhousing narrow block to borg warner box , would be good for a cut and shut
Cheers stealth
Cheers stealth
Engineering the unfair advantage !
Red bull , fuelling the fastest race cars on earth !
Red bull , fuelling the fastest race cars on earth !
Re: Alloy auto narrow block bellhousings
Stealth does it look something like this but alloy?
Re: Alloy auto narrow block bellhousings
No thats a auto bellhousing
Cheers stealth
Cheers stealth
Engineering the unfair advantage !
Red bull , fuelling the fastest race cars on earth !
Red bull , fuelling the fastest race cars on earth !