- VHT Wrinkle Plus Paint.
- Making Tape.
- Either 2 Hair driers or a heat gun. (Buy 2 hair driers as one could stop working mid way which you don't want. One is a back up.) - THIS ALSO DEPENDS ON WEATHER YOU WANT IT TO WRINKLE.
- Paint Stripper
- Sand Paper
Notes:
- Paint is very run-e.
- Paint in a X-cross pattern.
- Make sure to clean your rocket cover before painting, by this i mean clean it with warm hot water and use some wax and grease remover beforehand.
Steps:
1.) Paint strip and sand your rocket cover (Get it prepared for paint!)
2.) Mask off any hoses or bolts you do not wish to paint. Take time with this process as it will pay off in the end.
![Image](http://i40.tinypic.com/6t037o.jpg)
3.) Spray the rocket cover in different directions starting longways.
4.) Depending if you want it glossy or wrinkly... if wrinkly geat the heat gun/hair dryer out and heat it until you get you desired effect. Do it all over at the same pace and/or speed. If you want it glossy just paint it and leave it to dry.
5.) Finished!
![Image](http://i44.tinypic.com/24o1qmg.jpg)